Muchas gracias por su ayuda pero esa informacion, la informacion que requiero es: por ejemplo en labview realizo un encendido de un led o foco y apagado (booleano) requiero de alguna forma cargar el programa en el plc crouzet millenium 3 asi mismo darle una direccion en el plc al boton y al foco, despues deseo al mismo tiempo poniendo a correr los los dos programas realizados jutno al plc conectado al software del mismo y quiero moverle al boton de encendido y quiero que me encienda el foco del programa echo en labview y asi mismo el foco conectado al plc fisicamente les agradesco y me puedan ayudar.
Your Crouzet XD26 88970161 : -3-logic-controller-millenium-3-essential-expandable-range-with-display-xd26-Part%20number-88970161.htmIt costs 270 euros at Conrad.comI suppose you have the 24V DC version, and the inputs must be 24V as well.
Crouzet Millenium 3 USB Driver
The output of the PIR sensor is weak. You need a logic gate, or a comparator. Then you have to make 24V out of it. That is possible with a optocoupler, but there are other options.1 ) using two transistors.2 ) a good old comparator.3 ) using a chip for a relay / led / mosfet driver.4 ) using a special chip to convert the signal.5 ) using a fancy low input current opto-coupler with logic high voltage output.
I think the ULN2803 can also be used. It is 8 open collector relay drivers in a chip. You need to add an inverter chip.The TLP250 is a isolated gate driver or optodriver chip. That is such a fancy chip that I might have somewhere in a box. The TLP250 needs 10mA at the input, but there are chips that need only 1mA. 2ff7e9595c
Commenti